|
20 ![[Order-On-Line]](images/order1.jpg)
Made of flexible graphite particles
and high temperature lubricants for extreme service injectable packing.
Available In:
10-pack stick cartridges
2.2 lb
11 lb
22 lb Specifications |
|
25
Designed to be chemically a resistant product. This injectable packing has with bearing pellets for pressure compatibility. Ideal for the toughest applications.
|
26
FDA (food) applications require the injectable packing not contaminate your product. Ideal for your applications that cannot be stained. Our non-toxic fiber blended product with FDA-approved lubricants is ideal for clean or food grade applications.
Available
In:
10-pack stick cartridges
2.2 lb
11 lb
22 lb Specifications |
|
27
By combining PTFE/Graphite into a fiber we have created an injectable packing that is compatible with most chemicals, and resistant to abrasive service.
Available
In:
10-pack stick cartridges
2.2 lb
11 lb
22 lb Specifications |
|
29
Because of its high tensile strength-to-weight ratio; Aramid is 5 times stronger than steel. We use a blend of aramid fibers and
non-straining lubricants to make this a durable injectable packing for general service injectable packing.
|
|
The injection gun
The injection gun utilizes a button-head or
flow-through fitting permanently installed on the pump or valve stuffing
box.
Since it requires no electricity, the injection
gun can be used anywhere to replenish injectable packing easily
and conveniently. The all-steel hydraulic gun is completely portable
and is very easy to use.
The valve or pump stuffing box fitting allows the injectable packing to be hand-injected into
the shaft stuffing box using the injector gun. No downtime is required
for the repacking operation since the equipment can continue to
run during the repacking operation.
|
How to use the injection
gun
To properly replenish the injectable packing
material, the stuffing box fitting must be located. Next, the injection
gun is coupled to the fitting.
When the gun is properly coupled to the
fitting, the on-off handle on the fitting is turned to the open
position and the new injectable packing is pumped into the fitting
until the required amount of packing is injected.
When the operation is complete, the fitting
handle is placed in the off position and the gun is disconnected from the
stuffing box fitting. Remember to properly disassemble
and return your injection gun to its container where it may be stored
until needed again.
Note: Button-head fittings with check ball
valve do not required ball valve for on-line
repacking of injectable packing. |
